12.0.11

- Opening dimensions for Face Frame Cabinets should now be consistent between doors and drawers, regardless of interior space available
- Fixed an issue that could incomplete optimizations when choosing "Sequence by Cab#" and some parts were added in Optimize
- Fixed an issue where certain cabinet configurations weren't having fixed shelves dado into partitions properly
- Fixed an issue where multiple tops into a finished end weren't all receiving joint fastener operations
- Fixed an error that could occur when adding/adjusting cabinet heights
- Fixed an issue where standard drawer depths weren't being applied correctly in very long cabinets
- Fixed an issue in which cabinets with multiple generic "Face"-type sides were missing drawer boxes
- Fixed shelves with left/right adjustments should no longer have unnecessary blind notches or qualified dado grooves
- Fixed an error that could occur when attempting to optimize parts with 0 width or 0 length
- Fixed an issue where sometimes “rubber-band” selecting products in the Products Tab did not properly update the bottom panel

12.0.12

- Fixed an issue where the scrolling location of the product library tree in the Products Tab would sometimes initialize to the wrong location

- Implemented new KDT Autolabel post

- Fixed an issue where certain arced toolpath shapes were being output incorrectly by Holzher post

- Fixed an issue where pull holes on certain vertical grain pair doors were in the wrong location

- Fixed an issue where flip side arced toolpaths may be gcoded incorrectly

- Negative bulges that are smaller than the tool diameter should be ignored

- Fixed an incorrect gcoding issue that could be caused by certain small notches on cutouts/toolpaths