12.0.13
- Implemented CR Onsrud Autolabel post
- Fixed an issue where if length trim or width trim was set to 0, both trims were being set to 0
- Fixed an issue where blind notches set to almost 0 were causing incorrect dado grooves
- Fixed an issue where formulas that took points out of part bounds were causing strange shape behavior
- Fixed an issue in which printing from the Pattern Tab might run off the bottom of the page
- Fixed an issue in which ramping could sometimes gcode improperly on certain sharp corner toolpaths
- Fixed an issue in which equal door widths didn't update properly after changing end types
- Fixed an issue where if length trim or width trim was set to 0, both trims were being set to 0
- Fixed an issue where blind notches set to almost 0 were causing incorrect dado grooves
- Fixed an issue where formulas that took points out of part bounds were causing strange shape behavior
- Fixed an issue in which printing from the Pattern Tab might run off the bottom of the page
- Fixed an issue in which ramping could sometimes gcode improperly on certain sharp corner toolpaths
- Fixed an issue in which equal door widths didn't update properly after changing end types