Version 12.0.16

Uploaded May 22, 2023

Written By David Carr (Super Administrator)

Updated at May 22nd, 2023

Click HERE to download Version 12.0.16 - Uploaded May 22, 2023

12.0.14
- Fixed crash caused by manually making edits to PartLibrary.xml
- "Section Side" button was showing up in the Ends dialog incorrectly in certain cases
- Fixed an error that can occur when attempting to delete after moving to Elevation View with certain items selected
- Grouped/grain-matched parts were not flipping properly when autoflip was checked
12.0.15
- Fixed an issue that can result in incorrect line bore hole count on Weeke gcode output
- Created a Post to generate output for Felder F4Integrate
- Fixed an error that can occur when sending certain part shapes to cutlist with edge banding
- Linebores with only one hole should not check angle when determining whether to use Multidrill
- Fixed an issue that was preventing certain side shaped applied doors from being shaped (further issues on this particular ticket remain unfixed for now)
12.0.16
- Fixed an issue that was causing odd loops in certain pocketing shapes
- Fixed an issue that could cause incorrect shapes when notching shaped end panels for toes
- Fixed an issue where applied uends weren't properly going all the way to the floor in certain parameter setups